Hitachi Compute Blade 500 Series - Page 327

Tip: Available tasks depend on the physical drive status. Select from a list
displayed.
Menu items Description Reference
Select operation - -
Start Locate Turns on LED of the physical drive. -
Stop Locate Turns off LED of the physical drive. -
Place Drive Offline
1
Place the physical drive offline. -
Place Drive Online
1
Place the physical drive online. -
Initialize Drive
1
Initializes all areas of the physical
drive.
-
Drive Erase
1
Initializes all areas of the physical
drive.
-
Make Unconfigured Bad
1
Make the physical drive Unconfigured
Bad.
-
Make Unconfigured Good
1
Make the physical drive Unconfigured
Good.
-
Assign Global Hot Spare
Drive
Assign Global Hot Spare to the
physical drive
Assigning Hotspare
on page 5-41
Unassign Hot Spare Drive Unassign Hot Spare from the physical
drive.
Unassigning Hotspare
on page 5-43
Rebuild
1
Starts rebuilding. -
Note:
1. Do not select this item which is not supported.
Changing advanced settings on a physical drive
Follow the steps below to change advanced settings for a physical drive.
1. Select Advanced, and press Enter.
SAS 3004 iMR ROMB Configuration Utility
5-19
Hitachi Compute Blade 500 Series EFI User's Guide