Hologic Fluent Pro - Table 3: Real-Time Display, System Faults

Fluent Pro Fluid Management System
66 Troubleshooting English
5.3.10.3.1 System Fault Messages
Table 3: Real-time Display, System Faults
Fault Message(s) Resolution
Temperature Fault 1-4
Turn system off. Allow 5 minutes for system to cool down before turning the system on.
If problem persists, call Technical Support.
Sensor Data Missing Sensor calibration required. Call Technical Support.
FloPak Sensor Data Missing FloPak sensor calibration required. Call Technical Support
Memory Fault 2
Turn system off and on. Upon turning system back on, Last Procedure data may be
incorrect. If problem persists, call Technical Support.
System Watchdog Timeout Turn system off and on. If problem persists, call Technical Support.
Power Fault 1-6 Turn system off and on. If problem persists, call Technical Support.
Initialization Fault 1-8 Turn system off and on. If problem persists, call Technical Support.
Hardware Fault 1-7 Turn system off and on. If problem persists, call Technical Support.
System Fault 1-4 Turn system off and on. If problem persists, call Technical Support.
Internal Communication Fault Turn system off and on. If problem persists, call Technical Support.
Calibration Fault 1-4 Turn system off and on. If problem persists, call Technical Support.
Recovery Fault 2 Turn system off and on. If problem persists, call Technical Support.
Fluid Scale Fault 1-4 Turn system off and on. If problem persists, call Technical Support.
Waste Scale Fault 1-2 Turn system off and on. If problem persists, call Technical Support.
In-FloPak Fixed Pin Not Detected Turn system off and on. If problem persists, call Technical Support.
Inflow Sensor Fault 1-2 Turn system off and on. If problem persists, call Technical Support.
Inflow Motor Stopped Turn system off and on. If problem persists, call Technical Support.
Inflow Direction Fault Turn system off and on. If problem persists, call Technical Support.
Inflow Speed Fault Turn system off and on. If problem persists, call Technical Support.
Outflow Sensor Fault 1-2 Turn system off and on. If problem persists, call Technical Support.
Outflow Motor Stopped Turn system off and on. If problem persists, call Technical Support.
Outflow Direction Fault Turn system off and on. If problem persists, call Technical Support.
Outflow Speed Fault Turn system off and on. If problem persists, call Technical Support.
Pressure Sensor Fault 1-4 Turn system off and on. If problem persists, call Technical Support.
MyoSure Motor Stopped Turn system off and on. If problem persists, call Technical Support.