ThinPrep™ 5000 Processor with AutoLoader Operator’s Manual
6.57
USER INTERFACE
To test the slide ID configuration, use a labeled vial. Place the labeled vial into slot 1 of the input
carousel. Close the doors and press
Continue
to scan.
The instrument moves the vial in slot 1 of the carousel and scans the vial ID. The test not only checks
that the vial ID scanned matches the vial ID configured, but the screen display also shows a preview
of the information that will be etched onto slides, including the accession ID and any additional slide
configuration information.
To Next Page
Loading...
