Configuring Alarms | 101
800-11873V4 - A - 07/2014
Setting a Motion Detection File Name
You can specify a file name format for images uploaded when the motion alarm is triggered.
Choose the format that best meets your requirements.
1. In the File Name field (see Figure 6-11), type a file name (image.jpg is the default file
name).
2. Select one of the following options for the file name format:
• Add date/time suffix to add the date and time in YYMMDD_HHMMSS format (for
example, image120428_034724.jpg).
• Add sequence number suffix (no maximum value).
• Add sequence number suffix up to [number] and then start over, and enter a
value in the number field.
• Overwrite to overwrite an older file with a new file with a static filename.
Saving the Motion Detection Settings
After you have configured the motion detection settings for one of the four motion detection
profiles, click Save. Make sure to click Save before setting up another profile.
Save after you have configured all the motion detection settings for a motion detection profile.
See Selecting a Motion Detection Profile to Configure, page 95, Setting the Motion Detection
Status, page 95, Setting the Motion Detection Window, page 96, Setting the Motion Detection
Sensitivity, page 97, Setting the Motion Detection Actions, page 98, and Setting a Motion
Detection File Name on page 101 for more information.
Network Failure Detection Settings
You can set up the camera to send an alarm notification when a network failure is detected. You
can send a message to an FTP or email server, or you can record a video clip to a storage
device.
Setting Up Network Failure Detection
1. Navigate to System Events Network failure detection (see Figure 6-16).
Note The network failure detection Detection Switch is set to Off by default.
To Next Page
Loading...