Honeywell HDZ36EX - Enabling or Disabling the Home Function; Figure 5-7 Home Function Programming

Configuring PTZ Settings | 67
800-11873V4 - A - 07/2014
Note Be aware that you must enable the home function for your programmed home
function to be in effect (see Enabling or Disabling the Home Function on page 67).
2. Under Home setting, in the Time field, type a value from 1 to 128 minutes to set the
camera idle time limit (period of inactivity before the home function executes).
3. In the Type drop-down list, select the PTZ function you want the camera to execute when
the camera idle time expires. Choose one of the following options:
4. In the Line drop-down list, type or select the number of the PTZ function that you have
chosen (for example, you can choose Preset Tour number 3). The functions available for
selection change depending on what Function Type is selected (see step 3).
5. Click the Set button located below the Line field to save the settings that you have entered
for the Home Function.
Figure 5-7 Home Function Programming
Enabling or Disabling the Home Function
1. Navigate to PTZ  Home (see Figure 5-7).
• Preset • Preset Tour
• Autopan • Mimic Tour