www.honeywell.com/security
24 | HDZ Series IP PTZ User Manual
Accessories You Can Order Separately
There are a few accessories for your HDZ Series IP PTZ camera that can be ordered separately
(see Table 2-1).
Assembling the Camera
Camera assembly is quick and easy. To assemble the camera:
1. Take the camera and all other components out of the packaging.
2. Rotate and remove the protective cover bag from the camera body.
3. Use the torx driver to take off the dome cover.
4. Remove the foam and tape from inside the dome.
5. Remove the lens cap from the camera lens.
6. Use the torx driver to re-attach the dome cover to the camera body.
Note Optional: Use the lubricant on the dome cover’s rubber ring to make it easier to
re-attach to the housing and seal the PTZ dome cover and housing without water
coming in. Be careful to not get any lubricant on the dome as it may interfere with
viewing PTZ images.
7. Leave the protective film on the dome cover until installation is complete.
Mounting the Camera
You can install the camera to a ceiling, wall, pole, parapet, or roof using one of the following
Honeywell products:
Table 2-1 Orderable Accessories
Model Number
HDZIK10AC
a
a
HDZIK10AC is the default acrylic dome cover for the HDZ30HD and HDZ30HDE PTZ domes.
Clear IK10 vandal proof acrylic dome cover for the HDZ series.
HDZVRSMKAC Smoked PC vandal proof acrylic dome cover for the HDZ series.
HDZVRCLRAC Clear PC vandal proof acrylic dome cover for the HDZ series.
Note This part is for repair purposes only.
517082-7130 In-Ceiling PTZ support plate (for use with HDZINBKT in-ceiling mount).
To Next Page
Loading...