www.honeywell.com/security
134 | HDZ Series IP PTZ User Manual
Maintenance Settings
This section describes how to restore the camera to its factory default settings, how to manage
your configuration files, and how to upgrade the camera firmware.
Restoring Factory Defaults
You can either restore all the factory default settings, or all the factory default settings except for
the network settings. You can also reboot the system without restoring default settings.
Note There is also a Factory Default button on the bottom panel of the PTZ. Press this
button to restore factory default settings. See Table 2-3 on page 29 for more
information.
Restoring All Default Settings, Including the Network Settings
1. Navigate to System Factory Default (see Figure 7-20).
2. Click Set Default.
All changes are lost and the system restarts after 100 seconds. The camera’s IP address is
reset to the default setting.
Figure 7-20 Resetting to Factory Default Screen
To Next Page
Loading...