www.honeywell.com/security
96 | HDZ Series IP PTZ User Manual
Figure 6-10 Current Motion as Detected Window
1. Navigate to System Events Motion detection (see Figure 6-11).
2. Select a motion detection profile to configure (see Selecting a Motion Detection Profile to
Configure on page 95).
3. Under Motion Detection, select one of the following options:
• On to enable the motion detection profile.
• Off to disable the motion detection profile (default setting).
• By schedule to enable the motion detection profile based on a defined schedule
(refer to Schedule Settings on page 128 for information on setting up a schedule).
Note If you select By schedule, you will also need to select the schedule(s) to be used
for this selection. Click on the Please select field and select the check box for
each schedule to be used.
4. Click Save.
Setting the Motion Detection Window
A motion detection "window" or frame appears in the Live View screen to specify the area to
detect motion within (see Figure 6-11). You can add up to 10 motion detection windows. You
can move and resize the window to be wherever you want in the Live View screen.
Adding a Motion Detection Window
Click add to add a new motion detection window to the Live View screen (see Figure 6-11). You
can add up to 10 windows. The active window has a red border.
Deleting a Motion Detection Window
In the Live View screen, select the window that you want to delete (to make it the active window,
it will have a red border when active), and then click delete (see Figure 6-11).
The red line indicates the threshold
level of the motion sensitivity, as it
is currently set.
The blue line indicates the level of
motion that is currently being
detected by the camera.
To Next Page
Loading...