Honeywell HDZ36EX - Connecting the Cables

Installing the Camera | 29
800-11873V4 - A - 07/2014
Note Optional: the installer can use the lubricant on the rubber ring on the top of the
outdoor PTZ to make it easier to re-attach to the housing and seal the PTZ dome
cover and housing without water coming in. Be careful to not get any lubricant on
the dome as it may interfere with viewing PTZ images.
Connecting the Cables
Before connecting the cables, take a minute to familiarize yourself with the camera’s back plate
connectors, switches, and buttons, as shown in Figure 2-5 and Table 2-3 below.
Figure 2-5 Camera Back Plate Layout
Indoor IP PTZ Dome Camera
Outdoor IP PTZ Dome Camera
A
B
C
D
E
F
G
D
F
B
E
C
A
G
Table 2-3 Camera Back Plate Connectors, Switches, and Buttons
A RJ45 connector (see Connecting the Network Cable on page 31 for more information)
B Alarm Input/Output (see Connecting Alarm Inputs/Outputs on page 30 for more information)
a
C Power (see Connecting Power on page 32 for more information)
a
D MicroSDHC Memory Card Slot (install a microSDHC card from 8 to 32 GB, as needed). See
MicroSDHC Card Details on page 30 for more information.
E Factory Reset Button
b
F Audio Input/Output (see Connecting Audio on page 30 for more information)
a
G Eyelet to secure camera to building with lanyard during camera setup
a
Alarm, Power and Audio connections are made with removable connectors.
b
Press the factory reset button to restore all camera settings to the factory default settings.