Honeywell HDZ36EX - On Screen Display; Set Pan Zero; TV System

Configuring PTZ Settings | 85
800-11873V4 - A - 07/2014
Note This feature is only supported by the HDZ PTZ models: HDZ30(X) and
HDZ36E(X).
1. Navigate to PTZ
 Camera.
2. Under Misc (see Figure 5-14), in the Stabilizer drop-down list, select one of the following:
• On to enable image stabilizing.
• Off (default) to disable image stabilizing.
3. Click Set to save the setting.
On Screen Display
The on-screen display function (OSD) can be enabled to provide the user with directional
information for the focal point that the PTZ camera is facing. OSD information will include the
compass point that the camera is facing (North, South, East or West) and the zoom ratio that
the camera is currently using. The OSD will also provide the degrees that the camera is facing,
on both vertical and horizontal axes of rotation. See Figure 3-8 on page 44 to see an example of
the browser with the on-screen display showing the PTZ information on the video image.
Note This feature is only supported by the HDZ PTZ models: HDZ20HD(X),
HDZ20HDE(X), HDZ30HD, and HDZ30HDE.
Enabling/Disabling On-Screen Display
1. Navigate to PTZ  Camera.
2. Under Misc (see Figure 5-14), in the OSD drop-down list, select one of the following:
• On to enable the on-screen display.
• Off (default) to disable the on-screen display.
3. Click Set to save the setting.
Set Pan Zero
Click Set to set the pan setting to zero at the current PTZ camera position. Setting pan to zero
will set the current PTZ camera position as North. This setting will affect the direction information
that is displayed on the OSD (see On Screen Display on page 85 for more information).
TV System
Depending on the location that you are using the HDZ Series IP PTZ camera, you may need to
switch the TV System settings between PAL/NTCS. Generally, systems in North America use
NTSC and systems in Europe use PAL. If this unit was purchased in a PAL region, the camera