Honeywell HDZ36EX - Using Safety Cable During Installation; Figure 2-1 Eyelet on Camera to Secure by Lanyard During Setup; Table 2-2 Honeywell Mounts and Adapters

Installing the Camera | 25
800-11873V4 - A - 07/2014
Note An In-ceiling mounting bracket (HDZINBKT) is available. Check with your
Honeywell supplier regarding In-ceiling mounting. See Appendix B, In-Ceiling
Bracket Installation, for in-ceiling bracket mounting instructions.
For additional information, see Related Documents on page 18.
Using Safety Cable During Installation
The HDZ Series IP PTZ camera includes an eyelet for attaching a safety cable to securely fix the
camera to the mounting structure (see Figure 2-1). It is recommended that you install a safety
cable (such as a 3/32-in. [2.4 mm] plastic coated aircraft cable) to secure the camera to the
building structure. This will prevent the camera from falling during installation. The cable must
be strong enough to support the weight of the camera (indoor model: 4.9 lb. [2.2 kg], outdoor
model: 5.7 lb. [2.6 kg]).
Figure 2-1 Eyelet on Camera to Secure by Lanyard During Setup
Table 2-2 Honeywell Mounts and Adapters
Model No. Description Indoor Outdoor
HDCM1 Ceiling Mount X
HDXWM2 Wall Mount X X
HDPRM2 Parapet/Flat Roof Mount X X
HDZINBKT In-Ceiling mounting bracket for the HDZ series. X
HDXCMA1 Corner Mount Adapter for HDXWM2 X X
HDXPMA1 Pole Mount Adapter for HDXWM2 X X
Eyelet location on Indoor dome back panel Eyelet location on Outdoor dome back panel