www.honeywell.com/security
32 | HDZ Series IP PTZ User Manual
To power the camera, either PoE or a 24 V AC power connection can be used. If using PoE,
either a switch or PoE injector meeting the PoE+ standard (30 W) or High Power over PoE
(60 W), depending on the model, must be employed (see Table 2-7). See Connecting Power on
page 32 for more information about powering the HDZ series camera.
Note When connecting HDZ20HDE(X) with a PoE power supply, it is recommended to
use either an unshielded network cable or a shielded cable with an unshielded
pigtail connector.
Connecting Power
CAUTION
To power up the camera, either PoE+ or 24 V AC power
connections can be used. If using power over Ethernet (PoE+), please
connect the Ethernet cable to the camera’s Ethernet port and plug the
other end of the cable into an IEEE 802.3at-2009 High Power over Ethernet
(PoE Plus) switch. If there is a need to operate the Heater for the Outdoor
model, you will be required to use the 24 V AC cable to plug into the
camera’s power connector and power the camera.
IMPORTANT NOTE regarding PoE operation of models HDZ36E(X) and HDZ30HDE
A high power PoE injector capable of supplying at least 60 W is required for proper operation of
outdoor camera model HDZ36E(X) and HDZ30HDE as PoE to IEEE802.3af or IEEE802.3at will
not support these models.
Refer to Figure 2-8 and Table 2-8 when connecting power to your camera through the main
power adapter.
Table 2-7 PoE Requirements by HDZ Model
HDZ Camera Model PoE Requirement
HDZ20HD(X), HDZ30(X), HDZ30HD PoE+ (30 W)
HDZ30HDE, HDZ36E(X) PoE++ (60 W) supports camera and heater operation for outdoor
installations
HDZ20HDE(X) PoE+ (30 W) supports camera operation only. If installed outdoors and
heater operation is required, the camera must be powered by 24 V AC.
To Next Page
Loading...