www.honeywell.com/security
122 | HDZ Series IP PTZ User Manual
Figure 7-10 SNMP Network Settings Screen
Enabling SNMP (Version 1 or 2)
1. Navigate to System Network SNMP (see Figure 7-10).
2. Choose one of the following:
• To use SNMP version 1, select the Enable SNMP v1 check box.
• To use SNMP version 2, select the Enable SNMP v2 check box.
3. In the Read Community field, specify the community name (password) for read-only
access to all supported SNMP objects. The default value is <public>.
4. In the Write Community field, specify the community name (password) for read/write
access to all supported SNMP objects (except read-only objects). The default value is
<private>.
5. Click Save.
Enabling SNMP (Version 3)
1. Navigate to System Network SNMP (see Figure 7-10).
2. Select the Enable SNMP v3 check box.
To Next Page
Loading...