Honeywell HDZ36EX - Upgrading the Software

Configuring System Settings | 135
800-11873V4 - A - 07/2014
Restoring All Default Settings, Except for the Network Settings
1. Navigate to System  Factory Default (see Figure 7-20).
2. Click Set Soft Default.
All changes except the network settings are lost and the system restarts after 100
seconds.
Rebooting the Camera Without Changing the Current Settings
1. Navigate to System  Factory Default (see Figure 7-20).
2. Click Reboot.
The system restarts without changing the current settings.
Upgrading the Software
To upgrade the firmware:
1. Download the software upgrade file to your hard drive. Make a note of the file location.
2. Navigate to System  Software Upgrade (see Figure 7-21).
3. Click Browse to locate the upgrade file on your hard drive, and then click Open.
4. Select the file (uImage+userland.img) to upgrade from the drop-down list.
Note If a switch/main/module upgrade is needed, choose the appropriate upgrade file
from the drop-down list (switch.bin/main.bin/module.bin).
5. Click Upgrade.
6. After the upgrade is complete, close your browser.
7. Open the Start menu, click Control Panel, and then double-click Add or Remove
Programs.
8. Select Honeywell Viewer from the list of programs and then click Remove.
9. Open your web browser and access the camera (see Accessing the Camera from a
Browser on page 38). Then allow the automatic download of the Honeywell Viewer.