www.honeywell.com/security
118 | HDZ Series IP PTZ User Manual
Network Settings
This section contains instructions for assigning the camera a fixed IP address, setting the
camera to automatically obtain a DHCP assigned IP address, enabling PPPoE, configuring
ports, enabling IPv6 address configuration, prioritizing services, and enabling SNMP, UPnP,
and DDNS.
Basic Network Settings
The camera is assigned a dynamic (DHCP) IP address by default. Use the Honeywell Device
Search tool to find the automatically assigned dynamic IP address (refer to Finding the Camera
on a Network on page 35 for more information).
If required, you can assign the camera a fixed (static) IP address. You can also assign a fixed IP
address in the Honeywell Device Search application (see Assigning a Static IP Address to the
Camera on page 36 for more information).
Assigning a Fixed IP Address
If required, you can assign the camera a static (fixed) IP address (or a different fixed IP address).
You can also assign a fixed IP address in the Honeywell Device Search application (see
Assigning a Static IP Address to the Camera on page 36 for more information).
1. Navigate to System
Network Basic (see Figure 7-8).
2. Select the Use fixed IP address option in the General section of the screen.
3. Fill in the IP address, Subnet mask, Default gateway, Primary DNS, and Secondary
DNS fields.
4. Click Save under the PPPoE Password field.
To Next Page
Loading...