www.honeywell.com/security
80 | HDZ Series IP PTZ User Manual
Freeze
This feature is applicable to presets and preset tours. When the camera changes its position
according to a preset or preset tour, the video image shown is blurred and not recognizable due
to the speed that the camera pans and tilts. When the Freeze feature is enabled, the camera
freezes the current image that is displayed while moving to a preset or preset tour position.
When the camera reaches its destination, the video image will update to show the new field of
view.
Note This feature is only supported by the HDZ PTZ models: HDZ30(X) and
HDZ36E(X).
1. Navigate to PTZ
Camera.
2. Under Misc (see Figure 5-13), in the Freeze drop-down list, select one of the following:
• On to enable video freezing.
• Off (default) to disable video freezing.
3. Click Set to save the setting.
Image Flip
The image flip function lets you track an object continually as it passes directly beneath the
camera. You can select one of the following image flip modes:
Setting the Image Flip Mode
1. Navigate to PTZ Camera.
2. Under Misc (see Figure 5-13), in the Flip drop-down list, select one of the following:
• M.E. to enable the mechanical image flip mode.
• Image to enable the digital image flip mode.
• Off (default) to disable the image flip function.
3. Click Set to save the setting.
Table 5-3 Image Flip Modes
Mode Description
M.E. M.E. mode employs a mechanical image flip. As the camera tracks an
object passing underneath it, it tilts down to the maximum tilt angle, quickly
pans 180°, and then tilts upward to continue tracking the object.
Image Image mode employs a digital image flip. As the camera tracks an object
passing underneath it, it tilts down to the maximum tilt angle, reverses the
image digitally, and then tilts upward to continue tracking the object.
Off (default) Disable image flip mode.
To Next Page
Loading...