Figure 45 Removing the Left Access Panel
Replacing the Left Access Panel
To replace the left access panel:
1. Make sure the left access panel latch is in the open position (pointing up).
See Figure 46 (page 120).
2. Place the access panel onto the server blade by lining up the posts on each side of the access
panel with the keyways on the server blade chassis (1).
3. Slide the access panel toward the front of the server blade (2), and push down on the access
panel latch until it is flush with the access panel (3).
Removing and Replacing the Server Blade Access Panels 119
To Next Page
Loading...
