HP LaserJet Enterprise M607n - Page 264

Table 2-59 Support Tools menu (continued)
First level Second-level Third-level Fourth-level Fith-level Description
Paper Path Sensor
Test
Options
Done
Start
Number of Copies
Paper Tray
Output sides
Staple (SSMBM
models only)
Output Bin (the list of
output bins depends
on printer
conguration).
Done
Generates a test page
for testing paper path
sensors. Congure the
paper path used for
the test to test specic
paper path sensors.
A list of sensors
appears on the
control-panel display.
As the test page
prints, sensors in the
list toggle from an
inactive to active
state.
Manual Sensor Test All sensors
Input tray sensors
Output bin sensors
Engine sensors
Done
Reset
A list of sensors
appears on the
control-panel display.
When the sensor is
manually toggled, its
state changes from
inactive to active on
the control-panel
display.
Component Test Component (select
from a list of
components to test)
Repeat
Status (displays the
component status
during the test)
Done
Start
Drum motor
Alienation motor
Fuser motor
Tray 1 pickup solenoid
Tray 2 pickup solenoid
Tray 3 pickup solenoid
Tray 4 pickup solenoid
Tray 1 feed clutch
Tray 3 feed clutch
Duplex refeed clutch
solenoid
Switchback apper
solenoid
Laser Scanner Motor
NOTE: The list of
available components
to test depends on the
printer conguration.
Use this to test
various mechanical
and electromechanical
components.
Continuous Scan (MFP
models only)
2-sided (check box)
Done
Start
Use this to test the
sub scanner assembly
(SSA) optical scan
assembly.
238 Chapter 2 Solve problems ENWW