HP LTO Ultrium User Manual

DescriptionCode
The Logical Formatter has encountered a decompression error.302Eh
The Logical Formatter has encountered EOD.302Fh
The Logical Formatter failed to write a filemark — aborted.3030h
The Logical Formatter failed to write a filemark — data path not empty.3031h
The Logical Formatter failed to write a filemark — unsupported operation.3032h
The Logical Formatter has received a non-user data set.3033h
The Logical Formatter failed to write a filemark — packer paused.3034h
The Logical Formatter received an unexpected Access Point interrupt.3035h
The Logical Formatter was unable to insert an end marker.3036h
The Logical Formatter was unable to complete the new LTO5 Data Key process.3037h
Logical Media not able to supply any more datasets.3040h
Operation of the Logical Formatter’s Hardware Abstraction Layer has been aborted.3301h
Invalid parameter passed to a function in the Logical Formatter’s Hardware Abstraction
Layer.
3302h
A function in the Logical Formatter’s Hardware Abstraction Layer has detected an illegal
combination of variable values.
3303h
A function in the Logical Formatter’s Hardware Abstraction Layer has received a request
while in a mode that does not support that request.
3304h
The Logical Formatter’s hardware has failed to signal (issue an interrupt for) an event expected
by the firmware.
3305h
During a buffer transfer that ended with a final burst of ten bytes or less, the Logical Formatter’s
hardware failed to signal the transfer completion.
3306h
During a buffer transfer of ten bytes or less, the Logical Formatter’s hardware failed to signal
the transfer completion.
3307h
During a buffer transfer that ended with a final burst of ten bytes or less within the first 1k
DRAM page, the Logical Formatter’s hardware failed to signal the transfer completion.
3308h
A parity error was detected transferring data between Iona/Lucan and Amundsen.3309h
Wanted to start a timer for a potential missing NextDAEmpty interrupt but the pipeline was
not empty.
330Ah
LF’s C1LFI block detected a parity error while reading a byte out of its FIFO.330Bh
Logical Formatter detected a correctable SDRAM corruption during Restore.330Ch
Logical Formatter detected an uncorrectable SDRAM corruption during Restore.330Dh
Logical Formatter SDRAM corruption.330Eh
Logical Formatter pipeline stalled.3310h
Drive error codes100

HP LTO Ultrium Specifications

General

Category	Tape Drive
Capacity (Compressed)	Up to 30 TB (LTO-8), Up to 45 TB (LTO-9)
Transfer Rate (Compressed)	Up to 900 MB/s (LTO-8), Up to 1000 MB/s (LTO-9)
Interface	SAS, Fibre Channel
Technology	Linear Tape-Open (LTO)
WORM Support	Yes
Encryption Support	Yes (AES 256-bit)
Partitioning Support	Yes
Capacity (Native)	Up to 12 TB (LTO-8), Up to 18 TB (LTO-9)
Transfer Rate (Native)	Up to 360 MB/s (LTO-8), Up to 400 MB/s (LTO-9)
Backward Read Compatibility	Yes (LTO-8 reads LTO-7, LTO-6; LTO-9 reads LTO-8, LTO-7)
Backward Write Compatibility	Yes (LTO-8 writes to LTO-7; LTO-9 writes to LTO-8)