HP LTO Ultrium - Exception Handler (from 7800 H)

DescriptionError
DSP fault: unable to find a top servo band.7710h
DSP fault: unable to lock to track 0 on a top servo band.7711h
DSP fault: unable to verify band ID on a top servo band.7712h
DSP faults: spare.7713h–771Fh
DSP fault: the track-following loop could not stay at the desired set point.7720h
DSP faults: spare.7721h–772Fh
DSP fault: could not stay locked to the tape servo code.7730h
DSP faults: spare.7731h–773Fh
DSP fault: no tape servo data during seek acceleration phase.7740h
DSP fault: acceleration time-out fault.7741h
DSP fault: spare.7742h
DSP fault: no tape servo data during the seek deceleration phase.7743h
DSP faults: spare.7744h–7745h
DSP fault: seek failure during VI gross settle.7746h
DSP fault: seek failure during tape gross settle.7747h
DSP faults: spare.7748h–774Ah
DSP fault: no tape servo data during seek fine settle phase.774Bh
DSP fault: too few samples to generate an azimuth correction.774Ch
DSP fault: too few samples to generate a valid timing reference.774Dh
DSP faults: spare.774Eh–774Fh
DSP fault Code nn.
77nn h
(nn=50h–FEh)
Denotes the end of DSP error codes. This is not an actual error.77FFh
Exception handler (from 7800h)
DescriptionError
Unrecognized exception.7800h
A Fatal assert has been seen. Parameter 1 shows the PC, parameter 2 the error code for the
assert.
7801h
A Logged assert has been called. Parameter 1 shows the PC, parameter 2 shows the File ID,
parameter 3 the line number.
7802h
Drive error codes132