DescriptionCode
Aborted an active command.2408h
Aborted a command before it became active.2409h
Tried to abort a command that was not queued.240Ah
Invalid state requested of the EII State Manager.240Bh
The EII tried to process a firmware upgrade type that is not supported.240Ch
The EII state manager could not handle an abort request.240Dh
Tried to abort a command that was already being aborted.240Eh
Tried to get a command for the wrong module.240Fh
Command specified in eiNotifyOp would not have been top of queue.
2410h
Attempt to delete a queued EII command.2411h
Multiple attempts to delete an executing EII command.2412h
Attempt to queue a queued EII command.2413h
Attempt to queue an executing EII command.2414h
Attempt to remove a command from empty EII command queue.2415h
Attempt to execute a command still on the EII command queue.2416h
Attempt to execute an EII command when another is executing.2417h
Attempt to stop executing an EII command that was not executing.2418h
The module putting a command on the EII command queue is not the module that allocated
it.
2419h
Front panel interface (from 2800h)
DescriptionCode
Failure due to use of forced eject.2801h
Host interface (from 2C01h)
DescriptionCode
Unknown opcode.2C01h
Reserved field set.2C02h
Unknown mode page.2C03h
Volume 1: hardware integration 89
To Next Page
Loading...
