DescriptionCode
Expected a cleaning cartridge but got something else on load.1C18h
Cartridge Memory is unusable and failed to read the FID.1C19h
Firmware upgrade image information is unavailable.1C1Ah
Could not find firmware information in the new image.1C1Bh
A tape load has failed.1C1Ch
The EOD Validity field is not Good.1C1Dh
Firmware image is not compatible with drive sub-personality configuration.1C1Eh
A TMR timer fired but the ID does not match what was expected.1C1Fh
Firmware image has incorrect signature.1C20h
The firmware upgrade image is too old.1C21h
Firmware upgrade image version is too large.1C22h
Unknown tape format encountered during firmware upgrade.1C23h
Drive monitor (from 2000h)
DescriptionCode
No error. Synonymous with GOOD status.2000h
Invalid parameter. The value of a parameter received with a Drive Monitor operation falls
outside its valid range.
2001h
External interfaces (from 2400h)
DescriptionCode
Command holder full.2400h
Bad command handle.2401h
Empty command handle.2402h
No tape loaded.2403h
Already loaded.2404h
In diagnostic mode.2405h
Not in diagnostic mode.2406h
Tried to write to write protected cartridge.2407h
Drive error codes88
To Next Page
Loading...
