HP LTO Ultrium User Manual

DescriptionError
Invalid field in SCSI IU.982Dh
More data transferred than requested.982Eh
Task management function failed.982Fh
Service delivery failed.9830h
Invalid LUN in task management IU.9831h
Failed to transmit SCSI command or Task Management Function IU.9832h
Received zero length SCSI data IU.9833h
Received a data IU unexpectedly.9834h
Unexpected null frame pointer.9835h
The drive has detected a library firmware defect.9836h
Specified port is not a recognized ADT port.9837h
Instructs Bridging Manager not to resend a command with a UNIT ATTENTION sense key.9838h
A function will send a response when it has finished.9839h
The library NAKed a frame from the drive. Reported in the ADI/AMI command history log.983Ah
Reported in the ADI/AMI Command History log to indicate a PORT RESET event occurred
due to a diagnostic command.
983Bh
Not reported to a host but indicates a firmware defect sequencing a firmware reboot related
to an ADT RESET IU.
983Ch
GWIF pending.F801h
GWIF no change.F802h
Management API (from 9C00h)
DescriptionError
The Ethernet RESET line has been activated.9C01h
The System ARM maHandleEvent() function has received an illegal event.
9C02h
An invalid iADT port was specified for connection.9C03h
The iADT SENSEa input is asserted by the library controller.9C04h
The iADT SENSEa input is not asserted by the library controller.9C05h
The iADT SENSEa input has not been read yet.9C06h
Failure during socket read.9C07h
Volume 1: hardware integration 145

HP LTO Ultrium Specifications

General

Category	Tape Drive
Capacity (Compressed)	Up to 30 TB (LTO-8), Up to 45 TB (LTO-9)
Transfer Rate (Compressed)	Up to 900 MB/s (LTO-8), Up to 1000 MB/s (LTO-9)
Interface	SAS, Fibre Channel
Technology	Linear Tape-Open (LTO)
WORM Support	Yes
Encryption Support	Yes (AES 256-bit)
Partitioning Support	Yes
Capacity (Native)	Up to 12 TB (LTO-8), Up to 18 TB (LTO-9)
Transfer Rate (Native)	Up to 360 MB/s (LTO-8), Up to 400 MB/s (LTO-9)
Backward Read Compatibility	Yes (LTO-8 reads LTO-7, LTO-6; LTO-9 reads LTO-8, LTO-7)
Backward Write Compatibility	Yes (LTO-8 writes to LTO-7; LTO-9 writes to LTO-8)