HP LTO Ultrium User Manual

DescriptionError
The ADT Port interface received a SCSI operation from a device server with an invalid Context
ID.
9810h
Unable to generate a frame because it exceeds the maximum payload size.9811h
The ADT Port interface received more SCSI data than is permitted within a burst.9812h
The ADI Port interface has received a Data IU with an offset outside the current burst.9813h
The ADT Port interface received a command from a device server that it cannot support.9814h
The ADT Port did not receive an ACK for a frame it transmitted.9815h
Temp need to replace with SI_ERR_TASK_QUEUE_FULL when available.
9816h
Self-test failed: Unexpected FCBs allocated.9817h
Self-test failed: Unexpected exchange open.9818h
Self-test failed: Queue not empty.9819h
Self-test failed: SCSI Exchange not in the state IDLE.981Ah
The ADT port has detected an excessive number of framing errors.981Bh
Self-test failed: Non-zero library ACK offset.981Ch
Received Transfer Ready IU contained an invalid Buffer Offset field.981Dh
Received an ACK frame but not for frame it was expecting.981Eh
Received an NAK frame but not for frame it was expecting.981Fh
Giving up initiating a Port Login after a number of failed attempts.9820h
Discarding an ACK frame it received after the acknowledgement timeout.9821h
Did not receive acknowledgement within the Acknowledgement Period.9822h
Received a frame with a checksum error.9823h
Received a frame when the port was disabled.9824h
Received Transfer Ready IU was shorter than expected.9825h
Received Transfer Ready IU was longer than expected.9826h
Received Transfer Ready IU contained a Burst Length value of zero.9827h
Failed to execute a SCSI operation because it is logged-out.9828h
Failed to execute a SCSI operation because it is busy doing something else.9829h
Aborted bridged SCSI command due to a communication failure.982Ah
Unsupported task management function.982Bh
Invalid SCSI response code.982Ch
Drive error codes144

HP LTO Ultrium Specifications

General

Category	Tape Drive
Capacity (Compressed)	Up to 30 TB (LTO-8), Up to 45 TB (LTO-9)
Transfer Rate (Compressed)	Up to 900 MB/s (LTO-8), Up to 1000 MB/s (LTO-9)
Interface	SAS, Fibre Channel
Technology	Linear Tape-Open (LTO)
WORM Support	Yes
Encryption Support	Yes (AES 256-bit)
Partitioning Support	Yes
Capacity (Native)	Up to 12 TB (LTO-8), Up to 18 TB (LTO-9)
Transfer Rate (Native)	Up to 360 MB/s (LTO-8), Up to 400 MB/s (LTO-9)
Backward Read Compatibility	Yes (LTO-8 reads LTO-7, LTO-6; LTO-9 reads LTO-8, LTO-7)
Backward Write Compatibility	Yes (LTO-8 writes to LTO-7; LTO-9 writes to LTO-8)