DescriptionError
An invalid control word was found while parsing the Cal table to program a ASIC. Param
1 = control word, Param 2 = an integer value unique to each ASIC.
5861h
Could not write to Amundsen’s WEQ Control register.5870h
Illegal WEQ setup requested.5871h
The EEPROM calibration table area contains at least one invalid entry.5880h
The Per Drive Cal table in the EEPROM contains one invalid entry.5881h
The Per Drive Cal table in the EEPROM contains a revision number that is less than the revision
number found in the base Cal table.
5882h
rwc_estimate_boost.5890h
rwc_adjust_boost.5891h
rwc_boost_datasets.5892h
A request to reset the Afirs on the channel, Parameter1, was made to the RWC.5893h
Setup Servo.58F0h
SMUX.58F1h
BEN.58F2h
Undefined error.58FFh
System architecture (from 6400h)
DescriptionError
Formatter ASIC revision check failed. The ASIC is not a LTO 1 Formatter ASIC.6401h
The processor idle time is less than 30%.6402h
Tight integ (from 6800h)
DescriptionError
The Cmicro error handler function has been called (cm_ErrorHandler).
6801h
An implicit signal consumption has occurred.6802h
No free SDL timer storage (in SDLTimerFreeList) to set new timer — increase
MAX_SDL_TIMERS in TightInteg/cmTmr.c.
6803h
Volume 1: hardware integration 115
To Next Page
Loading...
