EasyManua.ls Logo

HP LTO Ultrium - Page 114

HP LTO Ultrium
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DescriptionError
Wrong number of parameters.5810h
Could not set Prometheus 0 to default values.5820h
Could not set Prometheus 1 to default values.5821h
Could not set Prometheus 2 to default values.5822h
Could not set Prometheus 3 to default values.5823h
A valid Mod level was not received from the PCA EEPROM.5824h
Could not set Prometheus 4 to default values.5825h
A failure was detected during a Write Element Resistance test for Artemis.5826h
A failure was detected during a Read Element Resistance test for Apollo.5827h
Artemis did not achieve PLL lock. Parameter 1 is Artemis (0=BumpA, 1=BumpB, FFh=No
Artemis was specified). Parameter 2 is value of the Artemis PLL register.
5828h
Could not set Hyperion 0 to default values.5830h
Could not set Hyperion 1 to default values.5831h
Could not initialize the Diagnostic Data rwInitDiagnosticData.
5840h
Did not get either INTODRIVE or INTOCARTRIDGE.
5841h
Delilah failed to autocalibrate.5850h
Gideon failed to autocalibrate: param1 = GideonRegisters, param2 = RegisterValue, param3
= nothing.
5851h
Gideon HyperTransport PLL failed to come out of reset: param1 = GideonRegisters, param2
= RegisterValue, param3 = nothing.
5852h
HyperTransport sync failure: param1 = bus, param2 = count, param3 = type.5853h
HyperTransport parity failure: param1 = bus, param2 = count, param3 = type.5854h
HyperTransport unexpected parity state at power-on: param1 = HT Parity Error, param2 =
HT Parity Error count 0, param3 = HT Parity Error count 1.
5855h
A valid Blo Dac Gideon Register setting could not be determined in the manual calibration
mode.
5856h
The Mech Interface firmware returned a failure to RWC firmware when requested to set an
ATS clock frequency for Gideon calibration.
5857h
The Random Bit Sequence generator failed to collect the required samples in the allowed
time.
5858h
A valid Blo Dac Gideon register setting could not be determined in the manual calibration
mode, retrying the Gideon offset calibration.
5859h
Expected a compatible data tape but got something else.5860h
Drive error codes114

Table of Contents

Related product manuals