HP LTO Ultrium User Manual

11 Drive error codes
The following error codes may be reported in bytes 16 and 17 of the Request Sense data and also
reported in ACI Get Error Info RDATA, bytes 3 and 4. See the REQUEST SENSE command in Chapter
4 of the Host Interface Guide, Volume 3 of the HP LTO Ultrium Technical Reference Manual.
Generic module (from 0000h)
DescriptionCode
Good.0000h
Bad.0001h
Done.0002h
Aborted.0003h
Invalid configuration values.0004h
Invalid configuration name.0005h
Place holder until real status is known.0006h
Invalid parameter supplied to function.0007h
Automation Control Interface (from 0400h)
DescriptionCode
Unsupported command opcode.0401h
Busy—command rejected.0402h
RAMBIST failed.0403h
Invalid command checksums.0404h
Invalid baud rates.0405h
Invalid command while load/unload pending.0406h
Time-out waiting to end immediate command.0407h
RAM framing error.0408h
RAM overrun error.0409h
Volume 1: hardware integration 79

HP LTO Ultrium Specifications

General

Category	Tape Drive
Capacity (Compressed)	Up to 30 TB (LTO-8), Up to 45 TB (LTO-9)
Transfer Rate (Compressed)	Up to 900 MB/s (LTO-8), Up to 1000 MB/s (LTO-9)
Interface	SAS, Fibre Channel
Technology	Linear Tape-Open (LTO)
WORM Support	Yes
Encryption Support	Yes (AES 256-bit)
Partitioning Support	Yes
Capacity (Native)	Up to 12 TB (LTO-8), Up to 18 TB (LTO-9)
Transfer Rate (Native)	Up to 360 MB/s (LTO-8), Up to 400 MB/s (LTO-9)
Backward Read Compatibility	Yes (LTO-8 reads LTO-7, LTO-6; LTO-9 reads LTO-8, LTO-7)
Backward Write Compatibility	Yes (LTO-8 writes to LTO-7; LTO-9 writes to LTO-8)