HP LTO Ultrium User Manual

DescriptionCode
Invalid command length .040Ah
Byte buffer framing error.040Bh
Byte buffer overrun error.040Ch
Command active abort rejected.040Dh
Invalid response acknowledgement.040Eh
Transmission time-out.040Fh
Did not receive ETX.0410h
Cancel command packet timer error.0411h
Custom byte error.0412h
Response acknowledgement time-out.0413h
Cancel response acknowledgement timer error.0414h
Unexpected byte received.0415h
Zero length command.0416h
Invalid command reserved field.0417h
RAMBIST did not complete.0418h
Ignored a byte received while transmitting response.0419h
Invalid CDB data length.041Ah
Firmware image too big.041Bh
ACI response is longer than the available buffer.041Ch
Did not receive acknowledgement to program flash.041Dh
Attempt to create a polling object instance without a polling function.041Eh
Attempted to create more polling object instances than the maximum allowed.041Fh
Attempted to access a polling object instance that does not exist.0420h
ACI command length is greater than the available buffer.0421h
ACI has run out of CRAM.0422h
ACI has received a firmware image larger than expected.0423h
An ACI command parameter contains an invalid value.0424h
ACI acMalloc() failed, insufficient memory available to process command.
0425h
ACI Control queue is full.0426h
ACI Response queue is full.0427h
Drive error codes80

HP LTO Ultrium Specifications

General

Category	Tape Drive
Capacity (Compressed)	Up to 30 TB (LTO-8), Up to 45 TB (LTO-9)
Transfer Rate (Compressed)	Up to 900 MB/s (LTO-8), Up to 1000 MB/s (LTO-9)
Interface	SAS, Fibre Channel
Technology	Linear Tape-Open (LTO)
WORM Support	Yes
Encryption Support	Yes (AES 256-bit)
Partitioning Support	Yes
Capacity (Native)	Up to 12 TB (LTO-8), Up to 18 TB (LTO-9)
Transfer Rate (Native)	Up to 360 MB/s (LTO-8), Up to 400 MB/s (LTO-9)
Backward Read Compatibility	Yes (LTO-8 reads LTO-7, LTO-6; LTO-9 reads LTO-8, LTO-7)
Backward Write Compatibility	Yes (LTO-8 writes to LTO-7; LTO-9 writes to LTO-8)