DescriptionCode
ACI Control queue is empty.0428h
ACI Response queue is empty.0429h
ACI Response packet was NAKed.042Ah
ACI attempted to execute an unsupported PPL command.042Bh
ACI has detected a command with a parameter out of range.042Ch
ACI attempted to execute a PPL command before the previous command completed.042Dh
ACI received more raw data than expected; see the Write Buffer PPL command.042Eh
Internal status indicating a slow ACI command rather than a fast one.042Fh
Internal status indicating an operation has initiated a DMA transfer.0430h
Internal status indicating that a firmware image has been downloaded so the firmware
should have been upgraded.
0431h
Internal status indicating that a firmware image download has been aborted.0432h
Surrogate SCSI command terminated due to a SCSI reset/abort for the LUN.0433h
ACI has not been allocated the amount of DRAM it requires.0434h
ACI has not been allocated the amount of CRAM it requires.0435h
An ACI surrogate SCSI command packet contained an invalid Exchange ID.0436h
A CDB contained an invalid exchange ID.0437h
ACI Surrogate SCSI queue is full.0438h
ACI Surrogate SCSI queue is empty.0439h
A request for an invalid entry in Surrogate SCSI queue has been made.043Ah
ACI has received an acSurrogateNotifyOp with an unknown SCSI CDB type.
043Bh
The SCSI Data Length parameter has changed unexpectedly.043Ch
Internal status indicating a PPL Command is being executed.043Dh
ACI too busy for fast command. Used in tracepoints to identify cause of
AC_BUSY_CMD_REJECTED error.
043Eh
ACI too busy for immediate command. Used in tracepoints to identify cause of
AC_BUSY_CMD_REJECTED error.
043Fh
ACI too busy for slow command. Used in tracepoints to identify cause of
AC_BUSY_CMD_REJECTED error.
0440h
ACI too busy for SCSI command. Used in tracepoints to identify cause of
AC_BUSY_CMD_REJECTED error.
0441h
ACI too busy because of overlapped commands. Used in tracepoints to identify cause
of AC_BUSY_CMD_REJECTED error.
0442h
Volume 1: hardware integration 81
To Next Page
Loading...
