Diagnostic control (from 1800h)
DescriptionCode
No errors.1800h
Invalid command.1801h
Invalid parameters.1802h
Drive not ready.1803h
Command failed.1804h
Command aborted.1805h
Too few parameters.1806h
Too many parameters.1807h
Command denied.1808h
Operation code not supported in diagnostic CDB command.1809h
Page code not supported in diagnostic CDB command.180Ah
Buffer code not supported in read/write buffer command.180Bh
Parity error on serial receive.180Ch
Framing error on serial receive.180Dh
Overflow error on serial receive.180Eh
Excessive input length, exceeding 220 characters.180Fh
Power-on self-test not executed.1810h
Error detected during the Register Walking 1 test.1820h
Built-in self-test failure.1821h
No test available for the parameters provided.1822h
Error detected during the Memory test.1823h
Power-on self-test failed the processor internal SRAM data bus test.1830h
Power-on self-test failed the processor internal SRAM address bus test.1831h
Power-on self-test failed the DRAM MPU Port test.1840h
Power-on self-test failed the DRAM Data Bus test.1841h
Power-on self-test failed the DRAM Addr Bus test.1842h
Power-on self-test failed the Formatter ASIC Register test.1843h
Power-on self-test failed the Formatter ASIC built-in self-test).1844h
Drive error codes84
To Next Page
Loading...
