DescriptionError
The value of TapeWritePassValue CurrentWrap and SDL sheet has been set.50A4h
Shows the value that the Max ATS has been set.50A5h
An error code of 7501h (Loss of LPOS) has been detected, causing a reduction in the servo
MR bias.
50A6h
A RampToSpeedRsp signal has arrived while trying to abort.50A7h
Excessive offtracks have been seen on a Fuji tape.50A8h
The drive tried to perform an ERT whilst the tape was not threaded.50A9h
The firmware may have followed a path in which the formatter was not aborted before a re-
write.
50AA
The firmware has managed to write a dataset that finishes past EOW.50ABh
An LTO 5 dataset was encountered whose Encryption Algorithm ID was not 02h.50ACh
Physical side error recovery (from 5400h)
DescriptionError
Not an error—just requests a trace log bank switch.5400h
Shows the LPOS and MM position for the start of tuning.5401h
Read/write control (from 5800h)
DescriptionError
Success.5800h
Null point.5801h
Invalid parameter.5802h
No hardware.5803h
SPI transfer error.5804h
Prometheus set error.5805h
Hyperion set error.5806h
Daughter set error.5807h
Calibration did not complete.5808h
Servo bias status false.5809h
Volume 1: hardware integration 113
To Next Page
Loading...
