DescriptionCode
Power-on self-test failed the Firmware Image Checksum.1845h
Power-on self-test failed the CRAM Data Bus test.1846h
Power-on self-test failed the CRAM Address Bus test.1847h
Power-on self-test failed the SCSI ASIC Register test.1848h
Power-on self-test failed the SCSI ASIC Buffer Data Bus test.1849h
Power-on self-test failed the SCSI ASIC Buffer Address Bus test.184Ah
Internal status instructing DI to exit Data Collection Mode.184Bh
Internal status instructing DI to execute the command as a Slow command.184Ch
Diagnostic Control has rejected a command because it is already executing a command.184Dh
Attempted to release Diagnostic Results memory that has not been allocated.184Eh
Unable to perform a Diagnostic command as the Diagnostic Results memory is already re-
served.
184Fh
Diagnostic Results data has overflow the memory allocated for results.1850h
DI has received an unsupported SCSI opcode in diExecScsiDiagOp.
1851h
DI attempted to set an illegal baud rate.1852h
Set Config attempted to set a read-only configuration.1853h
Indicates DI needs to send response in the Port buffer before completing the command.1854h
Power-on self-test failed the external SRAM Data Bus test.1855h
Power-on self-test failed the external SRAM Address Bus test.1856h
Internal status indicating that a Log command specifies an FLM log.1857h
Returned by some log extraction functions to indicate there is more data to extract.1858h
Comms error (such as framing or overrun) detected on the Serial Test port.1859h
The Serial Test port has timed-out while receiving data.185Ah
A device server has requested an operation not supported by diPortIF.
185Bh
Unable to get a new task object.185Ch
SCSI Command cannot be executed in Limited Operation Mode185Dh
Internal status instructing DI to send status before starting the protocol test.185Eh
Memory access denied to a READ/WRITE BUFFER command.185Fh
Memory access denied to a READ/WRITE MEMORY command.1860h
Power-on self-test failed; unrecoverable ECC error detected.1861h
Volume 1: hardware integration 85