EasyManua.ls Logo

HP LTO Ultrium - Page 82

HP LTO Ultrium
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DescriptionCode
ACI too busy because of comms resync. Used in tracepoints to identify cause of
AC_BUSY_CMD_REJECTED error.
0443h
ACI too busy because upgrading. Used in tracepoints to identify cause of
AC_BUSY_CMD_REJECTED error.
0444h
ACI too busy because out of memory. Used in tracepoints to identify cause of
AC_BUSY_CMD_REJECTED error.
0445h
ACI is resynchronising comms with library after persistant comms failure.0446h
SCSI opcode is not supported in this firmware release.0447h
Internal status indicating an ACI reset is required.0448h
Internal status indicating a full drive reset is required.0449h
Command contains an invalid Memory ID.044Ah
All Command Control Blocks have been allocated.044Bh
The returned or referenced Command Control Block is invalid.044Ch
Response Time-out command aborted and response sent.044Dh
Response Time-out response sent but command allowed to continue.044Eh
Response Time-out ACI failed to send response within the Response Period.044Fh
ACI too busy because the CCB queue is full. Used in tracepoints to identify the cause
of AC_BUSY_CMD_REJECTED error.
0450h
ACI command contains the sequence number of the previous command. The command
is ignored.
0451h
Internal status indicating a slow ACI command being executed before Drive Ready
event.
0452h
Failed to transmit ACK/NAK within the Packet Acknowledgement period.0453h
Internal status indicating a direct ACI command rather than a fast or slow one.0454h
ACI too busy for a direct command. Used in tracepoints to identify cause of
AC_BUSY_CMD_REJECTED error.
0455h
Cannot perform operation because the SCSI burst size is zero or unknown.0456h
Command not supported because the primary interface has not been enabled.0457h
Unable to get a new task object.0458h
An ADI frame has been received while one or more ACI commands are outstanding.0459h
An SOF was received in ACI Mode which was not a valid frame.045Ah
The SSC device has not requested the amount of data supplied with the ACI SCSI
command.
045Bh
The specified automation port is not supported.045Ch
Drive error codes82

Table of Contents

Related product manuals