DescriptionError
The specified scope trigger position is too large compared to the specified number of data
packets in the trace.
76F4h
The length of the buffer must be larger than zero and an even number.76F5h
The specified source number is not valid.76F6h
The specified scope buffer format parameter is not valid.76F7h
A reel driver calibration factor is out of range.76F8h
A reel driver calibration factor for static torque loss is out of range.76F9h
A reel driver calibration factor for dynamic torque loss is out of range.76FAh
The temperature is above the maximum limit.76FBh
The temperature is below the minimum limit.76FCh
EEPROM values are unavailable. The default servo tuning values are being used instead.76FDh
Previous fault conditions have made it unsafe to thread this cartridge.76FEh
The tape temperature is too high. Operations must stop and the cartridge must be ejected.76FFh
The base number for constructing DSP error codes. This is not an actual error.7700h
DSP fault: TMS320 was just reset due either to hardware pin assertion or receipt of the Reset
command.
7701h
DSP fault: the DSP checksum failed after a hardware/software reset.7702h
DSP fault: unsupported command opcode7703h
DSP fault: illegal command sequence.7704h
DSP fault: the Alert bit was set during a seek or CalibrateVI command.7705h
DSP fault: the DSP was asked to do a tape seek when the microprocessor said this was not
a safe operation to do.
7706h
DSP fault: a seek or VI calibration command was issued but the mechanism has not learned
the VI offset yet.
7707h
DSP fault: the stroke measured by the VI sensor hardware was not large enough.7708h
DSP fault: excessive actuator power amp offset.7709h
DSP fault: main memory microprocessor time-out.770Ah
DSP fault: the tracking PLL in the servo front end did not lock up at power up. Info only.770Bh
DSP fault: the servo firmware was sent a command it could not interpret .770Ch
DSP fault: no timers were available for use in the servo firmware.770Dh
DSP fault: spare770Eh
DSP fault: spare770Fh
Volume 1: hardware integration 131
To Next Page
Loading...
