DescriptionError
The write-protect sensor does not match the specified low state.76C0h
EEPROM values unavailable. Invalid table revision. Default servo tuning values are being
used instead.
76C1h
EEPROM values unavailable. Invalid table revision. Default values are being used instead.76C2h
The drive is not in the correct state to allow the power mode to be changed.76C3h
The power mode requested is invalid.76C4h
The cooling fan is stalled or running significantly below normal operating speed.76C5h
The cooling fan was stalled but is now operating normally.76C6h
A servo ARM memory parity error was detected. The drive must be reset.76C7h
A servo ARM memory parity error was detected. The drive must be reset.76C8h
A servo ARM memory parity error was detected. This is for information only.76C9h
A servo ARM memory parity error was detected. The drive must be reset.76CAh
Mechanism Inetrface resetting the drive. A fatal servo ARM memory parity error was detected.76CBh
The servo ARM did not respond within the allotted timeout, shutting down the actuator motor.76CCh
The drive is LOAD inhibited. The reel driver offset is out of range. Loading a tape would put
it at risk.
76CDh
Deceleration to the head turn-off speed took longer than expected.76CEh
The reel motor flex connection is suspect; the dataset field in the fault log indicates which
lines are in error.
76E8h
Tape tilt calibration failed. Drive write inhibited.76E9h
EEPROM values unavailable. Default DSP servo compensator values are being used.76EAh
The drive has cooled and the cooling fan has been turned off.76EBh
The drive is getting too hot and the cooling fan has been turned on.76ECh
The drive has cooled; resuming normal tape speeds.76EDh
The drive is getting too hot; tape speed is now being reduced to a minimum.76EEh
ASIC temperatures are too high. Operations must stop and the cartridge must be ejected.76EFh
The address into the main DRAM buffer must be on an even byte boundary.76F0h
The address into the main DRAM buffer is outside the range allowed for the servo system to
use.
76F1h
The specified mode is not valid.76F2h
The specified scope channel bit width is not supported.76F3h
Drive error codes130
To Next Page
Loading...
