DescriptionCode
Bad state—firmware defect.2CE0h
Bad configuration—firmware defect.2CE1h
The Host Interface ASIC has not responded to a mail-box operation within 10 ms.2CE2h
Got an internal firmware reboot.2CE3h
SCSI Bus Reset signal asserted by host.2CE4h
Bus Device Reset message sent by host.2CE5h
Transceivers changed to SE.2CE6h
Transceivers changed to LVD.2CE7h
Got a power-on reset.2CE8h
Checksum failure when copying bootloader code into Lucan dual-port RAM.2CE9h
Amunsden has been reset before receiving the hiPowerOneEvent from Iona.
2CEAh
LF stall on reads.2CEBh
Tape is threaded but the drive shows it as unloaded.2CECh
The ARM FW has determined that this is not a DR tape.2CEDh
There has been a change in the support Logical Unit inventory.2CEEh
An invalid Port ID has been logged in.2CEFh
An invalid LUN opcode has been passed to hiConfigureSurrogateLun().
2CF0h
Fixed mode request was too large.2CF1h
Decompression size mismatch while expanding and programming the Lucan FPGA code.2CF2h
Host interface has more to do.2CF3h
SCSI command failed because another host has changed the log pages.2CFDh
SCSI command failed because new firmware has been downloaded.2CFEh
SCSI command failed because another host has changed the mode pages.2CFFh
Hebrides is reporting a failure due to a read-ahead error.2D00h
Hebrides is reporting a failure due to a write-behind error.2D01h
Drive requested single shot read/write while streaming.2D04h
Search for a handle for a given context ID failed.2D05h
The dispatcher has completed the handling of the extended reset rewind.2D06h
Firmware upgrade or unknown cartridge loaded but not threaded.2D07h
Cleaning tape loaded but not threaded.2D08h
Volume 1: hardware integration 97
To Next Page
Loading...
Need help?
General
