HP MR Gen10 Plus User Manual

2.3 Transformation
2.3.1 Array transformations
2.3.1.1 Expand array
2.3.1.2 Replace Drive
2.3.2 Logical drive transformations
2.3.2.1 Transportable controller
2.3.2.2 Expand Logical Drive
2.3.2.3 Migrate RAID level
2.4 Drive technology
2.4.1 Hot-plug drive LED
2.4.2 Consistency check
2.4.3 Dynamic sector repair
2.4.4 Online drive firmware update
2.4.5 Predictive drive failure
2.4.6 Patrol read
2.5 Security
2.5.1 Drive erase
2.5.1.1 Simple
2.5.1.2 Normal
2.5.1.3 Thorough
2.5.2 Sanitize
2.5.3 Self-Encrypting Drive
2.6 Reliability
2.6.1 Cache Error Checking and Correction (ECC)
2.6.2 Thermal monitoring
2.7 Performance
2.7.1 Manage SAS storage link speed
2.7.2 Manage PCIe Storage Interface
2.7.3 FastPath
2.7.4 Cache
2.7.4.1 Read policy
2.7.4.2 Write policy
2.7.4.3 I/O policy
2.7.4.4 Drive caching
2.7.4.5 Strip size selection
3 Installation
3.1 Installing in a configured server
3.2 Installing in an unconfigured server
3.2.1 Installing the operating system with the controller driver
3.3 Configuring boot controller options
3.3.1 Selecting a boot mode
3.3.2 Changing the Legacy BIOS boot order
3.4 Connecting storage devices
3.4.1 Connecting internal storage

HP MR Gen10 Plus Specifications

General

Device Type	RAID Controller
Interface	PCIe 3.0 x8
RAID Support	Yes
Category	Controller
RAID Levels	0, 1, 5, 6, 10, 50, 60
Memory	2GB Flash-backed cache
Storage	SAS/SATA
Power Supply	Not Applicable