Using the OmniBook Docking Solutions
Operating the Docking Solutions
7-3
To dock the OmniBook
CAUTION
Use only an HP F1454A ac adapter (shipped with OmniBooks
compatible with this dock). Using any other ac adapter could damage
the OmniBook and may void your warranty. Refer to the warranty
statement for your product.
1. If you’re using Windows NT, click Start, Shut Down.
2. Plug the power cord into the ac adapter, then into an ac outlet. Plug the
ac adapter into the dock.
3. Place the OmniBook on the dock platform, with the rear of the
computer facing the dock’s docking connector.
4. Position your fingers on the platform grips as shown below. Use your
thumbs to push the computer into the dock until the computer slides
into place.
To Next Page
Loading...
Need help?
General