HP OmniBook 900 Evaluation Guide

Using Windows 98
Installing Pointing Device Support
4-11
Touch pad Driver
• Supports the enhanced features of the touch pad (no support for the
pointing stick)
To install the full pointing stick capabilities
Use this procedure install the full pointing stick capabilities. You’ll need
to do the following:
• Enable the pointing stick.
• Install pointing stick support.
Enable the pointing stick
1. From the Start menu, shut down, then restart the OmniBook.
2. When you see the HP logo, press F2 to enter the BIOS Setup utility.
3. Select the System Devices menu.
4. Highlight Internal Pointing Devices and select Pointing Stick. (Choose
Both if you want basic touch pad features available.)
5. Press F10 to save and exit.
Install pointing stick support
The pointing stick driver is on the OmniBook 900 Recovery CD in
\OMNIBOOK\DRIVERS\WIN98\TRACKPNT.
The pointing stick driver is on the OmniBook 900 B Recovery CD in
\OMNIBOOK\DRIVERS\W98\TRACKPNT.
1. From Control Panel, double-click System, then Device Manager.
2. Open PS/2 Compatible Mouse Port under Mouse.
3. Click Driver, the Update Driver.
4. Click Next.
5. Click Display a list of all the drivers in a specific location, so you can
select the driver you want and Click Next.
6. Click Have Disk
7. Enter the directory of the pointing stick drivers on the Recovery CD
and click OK.
8. Click Next to accept the IBM PS/2 TrackPoint driver.
9. Click Yes to Update Driver.
10. Click Next to accept Driver.
11. Click Finish.
12. Close the IBM PS/2 TrackPoint Properties window.
13. Close System Properties.
14. Shutdown and restart the OmniBook.

HP OmniBook 900 Specifications

General

Brand	HP
Model	OmniBook 900
Category	Laptop
Language	English