Using Windows 95
Installing Windows 95
5-3
Installing Windows 95
If you install a version of Windows 95, you’ll also need to manually install
video, audio, PC Card, and infrared drivers.
This section describes how to
♦ Prepare for software installation.
♦ Install Windows 95 OSR 2.x.
♦ Install video support for Windows 95.
♦ Install audio support for Windows 95.
♦ Install PC Card support for Windows 95.
♦ Install infrared support for Windows 95.
♦ Install USB support for Windows 95.
♦ Disable automatic CD-ROM detection for Windows 95.
♦ Install pointing device support for Windows 95.
♦ Install Euro key currency support for Windows 95.
♦ Install Windows 95 Y2K update for Windows 95.
♦ Install second hard drive Accessory Module support for
Windows 95.
♦ Install Accessory Module hot swap support for Windows 95.
♦ Install Docking System support for Windows 95.
Requirements
♦ OmniBook 900 with Floppy & CD-ROM drives.
♦ Omnibook 900 Floppy Disk Cable for external use through parallel
port (Part No. F1473A)
♦ Blank, formatted floppy disk
♦ Windows 95 OSR 2.x CD-ROM.
♦ OmniBook drivers for Windows 95 Location:
On the OmniBook hard drive: \OMNIBOOK\DRIVERS\ or on the
OmniBook 900 Recovery CD in \OMNIBOOK\DRIVERS\WIN95 or
in the OmniBook 900 B Recovery CD in
\OMNIBOOK\DRIVERS\W95.
To prepare for software installation
It is recommended you repartition your hard disk before installing
Windows 95. Follow the instructions below to format your hard disk. To
format the drive you’ll need a boot floppy with the proper disk tools on it.
This procedure will show you how to create a support utility disk that will
To Next Page
Loading...
Need help?
General