Using the Recovery CD
Recovering a Factory Build
3-5
To recover the Windows NT factory installation
(OmniBook 900)
The following procedure describes how to use the Recovery CD to recover
the original Windows NT 4.0 factory-installation that came with your
OmniBook.
Requirements
♦ CD-ROM drive for OmniBook 900.
♦ OmniBook Recovery CD.
Hint
This procedure will format the hard disk drive. Back up any files you
would like to save before installing Windows NT 4.0.
1. Connect the ac adapter to the OmniBook.
2. Connect the CD-ROM drive to the OmniBook.
3. Insert the bootable Recovery CD in the CD-ROM drive.
4. Reboot, press ESC twice and select the CD-ROM as the boot device.
5. When the menu appears, choose Recover Windows NT.
6. When prompted, select Y to erase the hard disk and continue.
7. After the hard drive is erased and partitioned, the OmniBook reboots,
press ESC twice and select the CD-ROM as the boot device.
8. The recovery process can take up to an hour. Do not interrupt the
recovery process or unplug the ac adapter until recovery is complete.
9. Insert a pen or straightened paper clip into the System Off button
located on the left side of the OmniBook.
10. After the computer shuts down, press the blue power button to turn it
on.
To Next Page
Loading...
Need help?
General