Using Windows NT 4.0
Installing Mobile Enhancements
6-11
To install Card Executive for retail Windows NT 4.0
To take advantage of Card Executive’s plug-n-play for PCMCIA network
cards, you must install Card Executive before installing Windows NT
networking. The driver is located on the OmniBook 900 Recovery CD in
\OMNIBOOK\DRIVERS\PCCARD. On the OmniBook 900 B Recovery
CD the driver is in \OMNIBOOK\DRIVERS\NT4\PCCARD.
Card Executive adds the following capabilities to your OmniBook:
• Plug and Play for PC Cards using standard Windows NT drivers.
• Plug and Play for supported network PC Cards.
• Automatic configuration of PC Cards utilizing advanced Wizard
technology to allocate system resources.
• Suspend/Resume functions and simplified administration of PC Cards
when integrated with Phoenix APM.
1. From the Start menu, click Run.
2. Go to the Phoenix Card Executive directory and run Setup.exe
3. Click the button to begin the installation process.
4. Click I Understand then click OK.
5. Click Restart Now.
6. After reboot, click Next to run the PC Card Diagnostics.
7. Make sure there are no PC Cards installed in the OmniBook and click
Next to start the Diagnostics.
8. Click Finish to reboot.
After reboot, the PC Card icon appears on the Taskbar.
To Next Page
Loading...
Need help?
General