To Next Page

To Previous Page

Using Windows NT 4.0

Installing Cards

6-18

8. If you chose not to use DHCP, you will be prompted to enter your

TCP/IP information.

9. If you chose to use DHCP, there will be a slight pause while it attempts

to find the DHCP server, click Yes when prompted.

10. When prompted, restart Windows NT 4.0.

Important

If you receive a network error in the Event log you must re-install

Windows NT 4.0 Service Pack 5.

To install a 3Com 3C575 Fast EtherLink XL CardBus PC Card

Requirements

♦ OmniBook 900 with Windows NT 4.0 installed.

♦ Windows NT CD-ROM.

♦ 3Com 3C575 Fast EtherLink XL CardBus PC Card.

♦ 3Com 3C575 Fast EtherLink XL CardBus PC Card Driver Disk.

Note

These procedures assume that Phoenix CardExecutive is installed and

Windows NT Networking has not been installed.

For more information on installing PC Cards in Windows NT, visit our

web site at www.hp.com/omnibook.

1. Start Windows NT 4.0.

2. Insert the PC Card.

3. When the PCMCIA Card Not Configured window appears, select

Install system provided driver for this card and click OK.

4. Insert the Windows NT Installation CD in the CD-ROM drive, enter

the correct directory and click OK.

5. Click OK to accept the Automatic configuration (IO Port and

Interrupt).

6. Click OK to the setup message. (The card has not been activated yet.)

7. If you wish to use DHCP, click Yes.