EasyManuals Logo

HP StorageWorks 1/8 User Manual

HP StorageWorks 1/8
204 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #127 background imageLoading...
Page #127 background image
Media
Once the data gets to the tape drive, it must be written onto the tape. If there are no bottlenecks and
the Autoloader starts having performance problems:
Try a new cartridge. A marginal cartridge can cause performance problems when the tape drive
has to retry writing to bad spots on the tape.
Clean the tape drive. See Tape cartridges on page 43 for instructions.
Service and repair
Releasing the magazines manually
If you cannot remove the magazines via the OCP or RMI, do the following:
1. Unplug the power cord from the device.
2. From the back of the device, find the access holes for the right and left magazines. See Figure
63.
Figure 63 Access holes for the right and left magazine
.
Right magazine release1.
Left magazine release2.
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 127

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP StorageWorks 1/8 and is the answer not in the manual?

HP StorageWorks 1/8 Specifications

General IconGeneral
Number of Slots8
Form Factor1U
InterfaceSCSI / SAS
Drive TypeLTO
CompatibilityCompatible with HP and non-HP servers

Related product manuals