Figure 60 Autoloader menu tree
.
The administrator password accesses all of the available functionality, except for the HP Service Area.
A user without the administrator password has access to the Unlock Mailslot and Status/Information
menus.
Entering the administrator password
TIP:
By default, the administrator password is unset; all of the digits are null. You must set the administrator
password from the OCP to protect the administrator functions on the OCP and enable the administrator
functions in the RMI.
Options that require a password will prompt for a password before allowing access to the restricted
screens. Once entered, the administrator password does not need to be entered again unless there
is no user activity for five minutes or the password lock is enabled.
The number 1 should be flashing. To enter the password, do the following:
1. From the operator control panel, press Next to scroll to the first number of the password.
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 85
To Next Page
Loading...
Need help?
General
