Operator control panel (OCP)
The operator control panel on the front of the device includes a 2-line by 16-character green backlit
liquid crystal display (LCD), four function keys, and four LEDs. This panel provides everything you
need to monitor the device status and control its functions.
The following functions are available through the OCP:
• “Unlocking the mailslot (Unlock Mailslot)” on page 86
• “Status/Information” on page 86
• “Inventory (Status/Information > Inventory)” on page 87
• “Autoloader information (Status/Information > Autoloader Information)” on page 88
• “Drive information (Status/Information > Drive Information)” on page 88
• “Component status (Status/Information > Component Status)” on page 89
• “Network information (Status/Information > Network Information)” on page 89
• “Configuration” on page 89
• “Changing the administrator password (Configuration > Change Admin Password)” on page
90
• “Setting the number of reserved slots (Configuration > Set Reserved Slot Count)” on page 90
• “Configuring the mailslot (Configuration > Configure Mailslot)” on page 91
• “Bar code reporting format (Configuration > Barcode Format Reporting)” on page 91
• “Changing the SCSI address — parallel SCSI devices (Configuration > Change Drive)” on page
92
• “Setting behaviors (Configuration > Autoloader Behavior)” on page 92
• “Setting the date and time (Configuration > Autoloader Date/Time)” on page 93
• “Configuring network settings (Configuration > Configure Network Settings)” on page 94
• “Configuring automatic cleaning (Configuration > Configure Auto Cleaning)” on page 95
• “Restoring factory defaults (Configuration > Restore Defaults)” on page 95
• “Saving and restoring the Autoloader configuration (Configuration > Save/Restore Configura-
tion)” on page 96
• “Operations” on page 97
• “Unlocking, removing, and replacing magazines (Operations > Unlock Left or Right
Magazine)” on page 97
• “Cleaning the tape drive (Operations> Clean Drive)” on page 97
• “Moving tapes in the Autoloader (Operations > Move Tape)” on page 98
• “Updating tape cartridge inventory (Operations > Perform Inventory)” on page 99
• “Rebooting the Autoloader (Operations> Reboot Autoloader)” on page 100
• “Enabling password locks (Operations > Enable Autoldr Password Locks)” on page 100
• “Support” on page 100
• “Powering a drive on or off (Support > Power On/Off Drive)” on page 101
• “Running the demonstration (Support > Run Demo)” on page 101
• “Running the slot to slot test (Support > Run Slot To Slot Test)” on page 101
• “Running the wellness test (Support > Run Wellness Test)” on page 102
• “Upgrading firmware (Support > Autoloader FW Upgrade, Support > Drive FW Up-
grade)” on page 103
• “Forcing the drive to eject a tape (Support > Force Drive To Eject Tape)” on page 105
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 81
To Next Page
Loading...
Need help?
General
