Figure 35 Status: Inventory: Media details pane
.
In the media details pane,
• Slot # — lists “Mailslot” or the index number of each slot in the magazine from lowest to highest.
• Attn — indicates an attention state for storage slots or provides information on the mailslot state.
• Status — Full or Empty.
• In Drive — shows when the tape from this slot is in a drive.
• Label — the bar code label data for the tape in the slot.
• Media Loads — the number of times this tape has been loaded into a drive in its lifetime. This
field may be blank if the tape has not been loaded into a drive in this device or if the inventory
has changed.
• Comment — any additional information about the tape in the slot (for example, Clean Tape if the
cartridge is a cleaning tape).
Configuration
Changing the system configuration
Use the “Configuration: System page” on page 62 to modify the system configuration.
System configuration changes are only applied after the Apply Selections or the Submit button is
selected. After making the selection, a warning page informs you of the impact of the proposed
change. In some cases a pop-up screen asks you to confirm the change. Many changes also require
the device to reboot. You may need to click Refresh to see the changes.
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 61
To Next Page
Loading...
Need help?
General
