To view more details about the contents of each slot, press Enter when the screen displays either Left
Magazine or Right Magazine.
To view the tape inventory:
1. From the Home screen, press Previous or Next until the screen displays Status/Information. Press
Enter to select.
2. Press Previous or Next until the screen displays Inventory. Press Enter to select.
3. By using Previous or Next, you can select from the following inventory locations:
• Left magazine — includes the mailslot
• Right magazine
• Drive
4. To view the inventory of a magazine, press Enter when the OCP displays Left or Right Magazine.
The OCP will display the contents of the lowest numbered slot in the magazine. The display will
show the tape bar code number, Full, or Empty.
5. Use Previous or Next to scroll through the remaining slots in the magazine. Press Cancel to choose
another inventory location.
6. To view the inventory of a tape drive, press Previous or Next until the screen displays Drive. The
display will show the tape bar code number, Full, or Empty.
Autoloader information (Status/Information > Autoloader Information)
To obtain information about your device:
1. From the Home screen press Previous or Next until the screen displays Status/Information. Press
Enter to select.
2. Press Previous or Next until the screen displays Autoloader Information. Press Enter to select.
By using Previous or Next, you can select from the following information screens:
• Autoloader Time
• Firmware rev.
• Product ID
• Serial number
• SCSI ID and LUN (SCSI devices only)
• Slots and Mailslots
• Odometer
• Power On Time
Drive information (Status/Information > Drive Information)
To obtain drive information:
1. From the Home screen, press Previous or Next until the screen displays Status/Information. Press
Enter to select.
2. Press Previous or Next until the screen displays Drive Information. Press Enter to select.
Operating the Tape Autoloader88
To Next Page
Loading...
Need help?
General
