3. By using Previous or Next, you can select from the following information screens:
• Serial number
• Drive type
• Firmware revision
• SCSI ID (parallel SCSI tape drives only)
Component status (Status/Information > Component Status)
To obtain component status:
1. From the Home screen, press Previous or Next until the screen displays Status/Information. Press
Enter to select.
2. Press Previous or Next until the screen displays Component Status. Press Enter to select.
3. By using Previous or Next, you can select from the following information screens:
• Drive activity
• Autoloader status
• Drive status
• Fan status
The second line of the screen will display one of the following:
• Good — the component is operating normally.
• Warning — the component might have an issue that should be addressed. The device is
functional.
• Critical — the component has an error condition that should be addressed. The device may
not be fully functional.
• Failed — the component has a known failure and should be replaced.
Network information (Status/Information > Network Information)
To access network settings for the device:
1. From the Home screen, press Previous or Next until the screen displays Status/Information. Press
Enter to select.
2. Press Previous or Next until the screen displays Network Information. Press Enter to select.
3. Press Previous or Next to access the following information:
• IPv4 Network Enabled or Disabled
• IPv6 Network Enabled or Disabled
• Host Name
• Domain Name
• MAC Address
4. For IPv4 Network or IPv6 Network, press Enter and then use Previous or Next to access the
network addresses and configuration.
Configuration
The Configuration menu provides access to the following configuration functions:
• “Changing the administrator password (Configuration > Change Admin Password)” on page 90
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 89
To Next Page
Loading...
Need help?
General
