Figure 22 RMI login page
.
The Account Types are:
• User — no password is required (leave the password box blank).
• Administrator — the administrator password is required. The same administrator password is used
for the RMI and OCP. There is not a default administrator password; the administrator password
must be set with the OCP before it can be used with the RMI. If the administrator password is lost,
contact HP to generate a temporary password that will grant administrator access.
• Service —access to this level is by HP Service personnel only. The service password is set at the
factory. The same service password is used for the RMI and OCP.
The user login provides access to the Identity and Status options, but not the Configuration, Operations,
and Support options. Administrator level provides access to all screens except for the Log configuration
and HP Service screens.
TIP:
By default, the administrator password is unset; all of the digits are null. You must set the administrator
password from the OCP to protect the administrator functions on the OCP and enable the administrator
functions in the RMI.
Status pane
The System Status pane (see Figure 23) shows the current device and drive status.
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 51
To Next Page
Loading...
Need help?
General
